INA bearing installation steps

- Jan 03, 2019-

1. Before installing the bearing on the shaft, the bearing pin of the bearing sleeve must be unplugged, and the surface of the journal should be smoothed and cleaned, and the oil should be rust-proof and lubricated at the journal (allowing the bearing to rotate slightly on the shaft).


2. Apply lubricant to the bearing seat and bearing mating surface, and insert the INA bearing into the bearing housing. Then the assembled bearing is placed on the shaft together with the bearing housing. Push to the desired location for installation.


3. The bolts of the fixed bearing housing should not be tightened first, so that the bearing housing can rotate in the bearing housing. Also mount the other end bearing and seat on the same shaft and turn the shaft a few turns to allow the INA bearing itself to automatically position itself. Then tighten the bearing block bolts.


4. Install the eccentric sleeve. First, eccentric sleeve is placed on the eccentric step of the inner sleeve of the bearing, and the shaft is tightened by hand in the direction of rotation. Then insert or hold the small iron rod against the counterbore on the eccentric sleeve. 1. Use the hammer to strike the small iron rod in the direction of rotation of the shaft. Install the eccentric sleeve securely and finally lock the socket head cap screws on the eccentric sleeve.